Step 13 Start Icemaker; Step 14 Install Toekick; Important; Inspect Final Installation - Monogram ZIP360NN Manual De Instrucciones

Installation Instructions - Standard Installation

STEP 13 START ICEMAKER

CAUTION
To minimize the risk of personal injury,
avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases the
cubes. Do not place fingers or hands on the automatic ice
making mechanism while the appliance is plugged in.
ATTENTION
Afin de réduire le risque de blessure,
évitez tout contact avec les pièces mobiles du mécanisme
d'éjection ou l'élément chauffant qui libère les cubes. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque l'électroménager
est branché dans la prise électrique.
PRECAUCIÓN
lesiones personales, evite el contacto con las partes móviles
del mecanismo eyector o con el elemento de calefacción que
libera los cubos. No coloque los dedos ni las manos en el
mecanismo de la máquina de hielo automática mientras el
electrodoméstico se encuentre enchufado.
OFF
ON
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, set the switch to O (OFF).
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.

STEP 14 INSTALL TOEKICK

• Locate the supplied toekicks (shipped taped to the
side of the refrigerator.
• Install the toekick assembly with the 2 screws
provided, adjust to the desired height and tighten the
screws.
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but
can NOT cover the horizontal vent slots of the factory
toekick.
31-1000451 Rev. 0
Para minimizar el riesgo de

INSPECT FINAL INSTALLATION

Check Door Alignment
Stand back away from the refrigerator to inspect the
final installation.
• Installation or the addition of heavy door panels
may have caused the doors to move slightly out of
alignment. Check to be sure the top of the doors
are evenly aligned with each other. If necessary, the
doors may be adjusted up or down to align.
• Add or subtract shims as shown to adjust the right
door only. More shims are located under the hood on
the left side in the bag with the filter bypass plug and
mini manual.
To Raise Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Snap a shim onto the hinge pin below the bushing.
• Lower the door and re-check the alignment.
• Repeat as necessary.
To Lower Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Remove a shim by pushing shim off of the hinge pin.
• Lower the door and re-check the alignment.
• Repeat as necessary.
23
Bag location
Shim