Step 12 Install Toekick; Inspect Final Installation - Monogram ZIP360NN Manual De Instrucciones

Installation Instructions- Stainless Steel Installation

STEP 12 INSTALL TOEKICK

• Locate the supplied toekick (shipped taped to
the side of the refrigerator). Install the toekick
assembly with the 2 screws provided, adjust to the
desired height and tighten the screws.
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but can
NOT cover the horizontal vent slots of the factory toe
kick.
31-1000451 Rev. 0

INSPECT FINAL INSTALLATION

Check Door Alignment
Stand back away from the refrigerator to inspect the
final installation.
• Installation or the addition of heavy door panels
may have caused the doors to move slightly out of
alignment. Check to be sure the top of the doors
are evenly aligned with each other. If necessary, the
doors may be adjusted up or down to align.
• Add or subtract shims as shown to adjust the right
door only. More shims are located under the hood on
the left side in the bag with the filter bypass plug and
mini manual.
To Raise Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Snap a shim onto the hinge pin below the bushing.
• Lower the door and re-check the alignment.
• Repeat as necessary.
To Lower Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Remove a shim by pushing shim off of the hinge pin.
• Lower the door and re-check the alignment.
• Repeat as necessary.
39
Bag location
Shim