Quick Start; Before You Start - Shoefresh SF50 Manual De Instrucciones

Quick start

step 1 – choose a good spot
Place your Shoefresh in a well-ventilated room,
for example the utility room, garage or hallway.
Make sure that the air inlet – the grille at the
rear of the unit – is not covered. Plug the unit
into the socket. The Shoefresh will now start.
step 2 – preparing the
shoefresh for use
Position the shoe holders as shown in figure 2.
Please note: the shoe holders will only fit into
the Shoefresh in one specific way. The chip
at the bottom of the shoe holder has to slot
exactly into the hole for the chip. Firmly push
the shoe holders into place until you see two
bars on the display. The Shoefresh stops after
about 10 seconds.
STep 3 – place a pair of ShoeS
on The ShoefreSh
Place the shoes over the holders as shown in
figure 3. The Shoefresh will start automatically.
The default for the unit is 5 minutes to remove
odour, followed by 20 minutes drying at 60
degrees. Once the program has finished, the
Shoefresh will stop automatically.
1.
2.
3.
16
before
you start
in this booklet
Congratulations with your purchase. In this
booklet you will find practical and technical
information about the Shoefresh.
what is the shoefresh?
The Shoefresh will freshen up and dry shoes in
two steps. During the first step (sterilization),
bacteria and fungi, which can cause nasty
odours, are tackled. During the second step
(drying), the shoes are dried, resulting in fresh
and dry shoes.
You can also use the Shoefresh to remove
odours, fungi and bacteria from and to
dry boots, helmets, socks, gloves and shin
protectors.
technical specifications
Voltage : 230V/50Hz/1PH
Power : 7-300W
17