Troy-Bilt TB495 Manual Del Operador página 10

WARNING:
unplugged when
adjustment.
NOTE: The assembly required for your
trimmer is to install the debris shield, the
assist handle and 2 divided shafts.
ASSEMBLY OF 2 SHAFTS
1. Remove and discard the rubber grommet
( packing material ) before assembling
upper and lower shafts. ( Fig.1)
Fig. 1
2. Align 2 arrows on upper and lower shaft
as shown in Fig.2.
Fig.2
3. While pushing up on the shaft length
adjustment button (A), slide upper shaft
over lower shaft until it locks in place.
The shafts will not come back apart.
NOTE: Once the upper and lower shafts
are assembled, they will not separate again.
ASSEMBLY INSTRUCTIONS
INSTALLATION OF ASSIST HANDLE
1.
Be sure unit is
making any
2.
3.
10
Remove nut and bolt from handle
before assembly.
Place the assist handle on the upper
shaft (some force is required) Fig 3.
Tighten the adjustment knob and bolt.
(Fig. 4.)
Fig. 3
Fig. 4