Adjustment Instructions - Troy-Bilt TB495 Manual Del Operador

WARNING:
unplugged when
adjustment.
ADJUST SHAFT LENGTH
1. Grip shaft firmly.
2. Push shaft length adjustment button (B)
and move upper shaft up or down to
desired length. (Fig. 7)
NOTE: Shaft may be adjusted in trimming
or edging mode.
Fig. 7
EDGING CONVERSION
1. Grip shaft firmly.
2. Press the edging conversion button (C)
(Fig. 8) and rotate the handle assembly
until it locks in place. (Fig. 9 normal
trimmer mode & Fig. 10 edging mode)
Fig. 8

ADJUSTMENT INSTRUCTIONS

Be sure unit is
making any
ADJUST THE ASSIST HANDLE
1.
2. Tighten adjustment knob securely.
ADJUST
ANGLE
1. Squeeze the adjustment buttons (D) at the
2. There are 4 settings to allow you to angle
12
Fig. 9 ( normal trimmer mode)
Fig. 10 (edging mode)
Loosen adjustment knob and move
handle to a comfortable position on the
upper shaft.
THE TRIMMER
bottom of the shaft. (Fig. 11)
Fig. 11
the shaft as needed to reach under decks,
bushes etc.
SHAFT