Imetec L1907 Manual De Instrucciones página 19

If the brush is still dirty:
• remove the brush locking screw (13c) using a screwdriver, turning it anti-clockwise
[Fig. G1]
• remove the brush block (13d) [Fig. G2]
• remove the brush (13e) [Fig. G3]
• Clean the brush using a moist cloth or a brush.
• Put the brush (13e) back in place [Fig. G2]
• remove the brush block (13d) [Fig. G3]
• Fasten the brush locking screw (13c) using a screwdriver, turning it clockwise [Fig. G1]
CLEANING THE DUST COLLECTION SYSTEM (11):
WARNING! Empty the dust container and clean the
filters after every use in order not to damage the
appliance.
NEVER fill the compartment above the permitted
MAX level (11D).
• Clean the dust collection system following the instructions below and paying attention
to the figures in the illustrative guide.
• Pull the dust collection system release lever (14) and detach the dust collection system
(11).[Fig. F1].
• Extract the filtering system (11B and 11d) [Fig. F2] and empty the contents of the dust
collection compartment (11a) [Fig. F3].
• Separate the filter protection mesh (11B) from the cyclone filter (11C) by pulling its rim
[Fig. F4] and clean them both by shaking and brushing the dust off with care. To do so,
use a soft brush to prevent any damage.
If suction power does not increase after cleaning the dust collection compartment (11a) and
the filtering system (11B and 11C), replace filter (11C) with a new one.
NOTE:
• Replace the filter if damaged or impossible to be thoroughly cleaned.
• Replace the filter at least once a year.
• Failure to clean or replace the filter will make the manufacturer's warranty
null and void.
Put the filtering system (11B+11C) back inside the dust compartment (11a) and reattach it
to the sweeper body, being careful to hook it onto the suitable bottom fitting and making the
dust collection system release lever click (14).
WARNING! Let the filters dry completely after washing
them for at least 24 hours before reassembly.
EN
17