Storing And Caring For The Product; Troubleshouting; Disposal - Imetec L1907 Manual De Instrucciones

STORING AND CARING FOR THE PRODUCT

If the appliance is not used, disconnect the plug (7) and store the appliance in a dry and
EN dust-free place.
PROBLEM
The appliance does not
go on.
The appliance switches
off
during use and does not
switch back on again.
The vacuum cleaner
does not suction well.
The product is packaged in recyclable materials. dispose of it in accordance with
the environmental protection regulations.
Pursuant to directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the crossed bin symbol on the appliance or its packaging indicates that the
appliance must be disposed of separately from other waste at the end of its useful
life.
The user must therefore take the appliance to an appropriate recycling centre for electrical
and electronic equipment. alternatively, instead of handling the disposal, the appliance
can be handed over to the retailer when a new, equivalent appliance is purchased.
Electronic products that are to be disposed of measuring less than 25 cm may also be
handed to retailers of electronic products having a sales area of at least 400 m
charge and with no obligation to buy. appropriate separate collection for the subsequent
procedure for the decommissioned appliance for recycling, which includes treatment and
environmentally friendly disposal helps prevent adverse effects on the environment and
health and promotes reusing and/or recycling materials that the appliance consists of.
DISPOSING OF THE BATTERIES
This product contains a rechargeable Li-ion type battery.
Remove the batteries from the appliance before disposing of it.
18
TROUBLESHOOTING
• Check whether the battery is charged.
• Make sure the plug is disconnected (7) from the socket. When
the plug is connected to the socket, a battery protection system
will stop the appliance from starting up.
• Make sure that the ON/OFF switch (8) has been pressed.
• The battery is flat. Charge the battery.
• If the problem continues, the battery needs to be replaced.
Contact a technical assistance centre.
• The dust collection system is full: empty the dust collection
compartment (11a).
• The filter is clogged: clean or replace the filter (11C).
• The filter is not fastened correctly: ensure the filter (11C) is
fitted correctly.

DISPOSAL

SOLUTION
, free of
2