BOND MANUFACTURING HYFP20018-10 El Manual Del Propietario página 7

5.Connect the rear panel
to the table top by 2 pcs
of M5x10 screws. See
Figure 5.
6.Attach the two side
panels to the table top
by 2 pcs of M5x10
screws. See Figure 6.
STEP 3.
(I)Make sure the gas valve is turned "OFF" before
assembling. Check each part before using the product. To
set the gas tank in the firebowl, screw the tank from the
bottom of the Pedestal to the regulator inlet fitting inside
the firebowl. See Image I.
(II) Place the lave rocks and logs on the burner averagely.
See Image II.
(III) After assembling the gas tank, open the door and
push and turn the Control Knob counter-clockwise, then
use a match or a lighter to light the firebowl. To adjust the
flame, turn the Control Knob. Push and turn the Control
Knob clockwise to turn the flame off.
See Figure III.
STEP 4. LEAK TEST
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Connect cylinder to regulator. Turn the on/off valve at the unit to the 'off' position to pressurize the control system. Use a
soapy water solution to check all the connections leaks before attempting to light the appliance. If a leak is found or you
smell gas, disconnect cylinder and turn valve off and do not use the appliance until repairs can be made.
TIPS:
Before Beginning ●Read the instructions thoroughly.
Caution:
*If the burner does not ignite but leave the valve open, gas will continue to flow out of the burner and could
accidently be ignited with the risk of injury.
Figure 5
● Check and make sure that all parts are present.
● For future reference, save this owner's manual.
Figure 6
I
II
7
III