Chaparral 544W Instrucciones Para Armar página 4

N
x 8
M
x 8
O
x 2
FIG. 2
READ RAFIX ATTACHMENT
SYSTEM INSTRUCTIONS NOW.
2. Tap in four Rafix Cams (M), with notch facing the edge, in each Shelf (F).
Screw Rafix Bolts (N):
• Four in Left Side Assembly (A)
• Four in Right Side Assembly (D)
*Note: To correctly position the bottom shelf, screw in two Rafix Bolts in the lowest row of shelf holes
on each side assembly (A & D). Choose any other row of holes to position the additional shelf.
P
x 1
Q
x 2
FIG. 3
Flush to Bottom edge
(not cleat)
3. Attach Sleeper (B) to Left Side Assembly (A) gluing Wood Dowel (O) and securing with Screw
(P) as shown in FIGURE 3. Make sure the edge of the Sleeper (B) stays straight and flush to
the edge of the Left Side Assembly (A).
Position the Base (C) so that the arch is down and the radius edge is up and out from the
unit. The bottom edge of the Base (C) needs to be flush with the bottom edge of the Left Side
Assembly (A). Use two Screws (Q) through the cleat to secure the Base (C) in place.
Slide a Shelf (F) onto bottom row of Rafix Bolts (N) on Left Side Assembly (A). Make sure the
Rafix Cams (M) are pointing down. Also, check that the back of the shelf is flush to the back
of the unit. If not, the shelf is in backwards. Rotate shelf 180 degrees and reinstall onto Rafix
Bolts (N). Tighten Rafix Cams (M) once the Shelf (F) is correctly positioned.
Page 4 – 544W
O
N
N
N
N
*
*
Glue Wood Dowels (O):
• One in Left Side Assembly (A)
• One in Right Side Assembly (D)
Stain Test
Area
Q
Q
BOTTOM
M
M
M
M
M
M
M
M
M
M
M
N
N
Flush with Back Edge
M
O
N
N
N
N
*
*
Insert Rafix
*
Bolts in these
holes for
bottom shelf
P
O
Flush with
Top Edge
TOP
BACK