Chaparral 544W Instrucciones Para Armar página 7

T
x 4
U
x 4
Q
x 4
READ CAM-LOCK INSTRUCTIONS
8. Insert four Cam Connectors (T) in the Drawer Front (H). Attach Left Drawer Side (I) and
Right Drawer Side (J) to Drawer Front (H) with four Cam Housings (U). Make sure that the
Cam Housings are facing out from the drawer and the grooves for the drawer bottom match.
Tighten cam housings. Slide the Drawer Bottom (K) into the grooves. Attach the Drawer End
(L) to the sides using Screw (Q) as shown in FIGURE 8A.
Square the drawer by measuring from left front to right rear and from right front to left rear.
The measurements should be equal. If one is longer, hold the drawer by the corners on the
longest line and squeeze them together until square. See FIGURE 8B.
W
x 4
W
FIG. 9
9. Attach Drawer Slides (Drawer Side Left) (V4) and (Drawer Side Right) (V3) to the drawer.
The wheels should be to the rear and the front edge should be flush against the back of the
Drawer Front. Attach each slide with two Screws (W). See FIGURE 9.
T
U
Q
Q
FIG. 8A
V4
W
T
U
V3
W
Q
Q
FIG. 8B
The drawer slide will be stamped with an
"L" for left or an "R" for right in the center of
the wheels. Or they will be stamped on the
body of the slide: "DL" for drawer left; "DR"
for drawer right.
W
544W – Page 7