Prepare For Installation - GE IM-5D Manual Del Propietário

INSTALLING ICEMAKER

PREPARE FOR INSTALLATION

1
• Pull the freezer door open to full extension .
• Remove 3 attachment screws, located at
the bottom on each side of the freezer door
using 3/8" hex socket driver .
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to
secure the door before lifting .
• Lift the freezer
door to
disengage it
from the slide
mechanism
• The door can
safely rest on
the bottom . Do
not rest the door
on any other
surfaces to avoid
scratches .
REMOVE FREEZER DRAWER
2
• Remove the top freezer drawer by fully
extending the drawer then lifting up and out .
• Push the bottom
basket back
until the slide
mechanism self
retracts .
Installation Instructions
3 Screws
REMOVE THE OUTLET COVERS
3
• Inside the freezer,
remove the 2
outlet covers from
the side wall .
• Remove the outlet
covers with a
small flat-blade
screwdriver .
For round
cover: Insert the
screwdriver into
one of the smaller
outermost slots
and push in firmly
to release the
round cover .
For rectangular
cover: insert the screwdriver into the slot at
the top of the cover . Lift the screwdriver up
to release the snap and pull the cover out
away from liner . (This part is disposable and
may break when removed . )
• Remove the icemaker power cord plug from
the pocket in the side wall .
INSTALL THE ICEMAKER FILL CUP
4
• Remove the ice maker
from the kit, install the
icemaker fill cup that
came with your kit
into the icemaker as
shown .
For New Install
• Choose the
appropriate size
ice bucket from
the kit . Place the
ice bucket in the
left side of the
freezer basket,
upside down,
with taller end
toward the rear
of the basket .
Outlet covers
Icemaker power cord
9