Connecting; Connecting A Cellular Phone - Sony DSX-S300BTX Manual De Instrucciones

Ocultar thumbs Ver también para DSX-S300BTX:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
If passkey* input is required on the
display of the device to be connected,
input "0000."
XXXX
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, this unit is ready for connection to the
device.
4
Set the Bluetooth device to connect to
this unit.
"Connection Complete" appears and
connection is complete.
" " or "
" appears when the connection is
made.
* Passkey may be called "passcode," "PIN code," "PIN
number" or "password," etc., depending on the
device. If the device supports Bluetooth version 2.1,
passkey input is not required.
Notes
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this
unit from another device.
• It may take time to search or connect.
• Depending on the device, the confirmation display of
the connection appears before inputting the
passkey.
• The time limit for inputting the passkey differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).

Connecting

If pairing has already been achieved, start
operation from here.
Input passkey.

Connecting a cellular phone

"0000"
1
2
Connecting to the cellular phone
last-connected from this unit
1 Be sure that both this unit and the cellular
2 Press (SOURCE/OFF) repeatedly until
3 Press the multi way encoder.
Notes
• Some cellular phones require permission to access
their phonebook data during handsfree connection
to this unit. Obtain permission via the cellular phone.
• While streaming Bluetooth audio, you cannot
connect from this unit to the cellular phone. Connect
from the cellular phone to this unit instead. A
connecting noise may be heard over playback
sound.
Tips
• With Bluetooth signal on: when the ignition is
switched to on, this unit reconnects automatically to
the last-connected cellular phone. But automatic
connection also depends on the cellular phone's
specification. If this unit does not reconnect
automatically, connect manually.
• You can also select the Bluetooth Phone source by
pressing and holding
2 or more seconds, or pressing (CALL) on the card
remote commander.
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
Connect to this unit using the cellular
phone.
" " appears when the connection is made. If
you select the Bluetooth Phone source after
the connection is made, the network name
and the connected cellular phone name also
appear in the display.
phone are switched to Bluetooth signal on.
"Bluetooth Phone" appears.
" " flashes while the connection is being
made. " " stays lit when the connection is
made.
(BROWSE) on this unit for
31

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido