Publicidad
Idiomas disponibles
Idiomas disponibles
6. Upon battery replacement, deactivate the unit by pressing and holding the
power button for 3 seconds. Disconnect Memory Saver from vehicle and store
the OBDII cord.
Note: If the unit is powered and idle for 4 hours, it will automatically turn off.
Preserve Vehicle Memory and Presets
(Connected via provided Male-Male DC Cord)
Note: Make sure that the Memory Saver is fully charged prior to using it for this
purpose to ensure it has enough reserve capacity to accomplish its task.
1. Prior to using, verify all vehicle loads and accessories are OFF. To prevent damage,
do not use Memory Saver if vehicle's current draw is 4 amps or more when the
vehicle is OFF.
Note: Vehicle systems often cycle after the vehicle is turned off. Cycling places
demands on the vehicle's electrical system. Before using the Memory
Saver, turn the vehicle OFF and wait for 25 minutes. Doing so will ensure
that all vehicle cycling is completed (most vehicles).
2. Connect one end of the provided Male-Male DC cord to the vehicle's power port.
Make sure the connection is secure.
3. Connect the other end of the provided Male-Male DC cord to the Memory Saver's
power port. Make sure the connection is secure.
4. Press the Power Button
get a Green 100% charged light indicating the unit is ready for service. If you get a
~75% charged light, you will have only a limited amount of reserve capacity to work
with. The unit should be recharged. If the red LED (<50%) is lit or no LED lights,
recharge the unit immediately.
5. Disconnect the vehicle's battery cable terminals and replace the battery.
Note: To prevent short circuit and loss of vehicle memory, do not allow
vehicle's disconnected battery cables to touch each other or a vehicle
ground.
and hold for 3 seconds to activate the unit. You should
Publicidad
