Kärcher D 110 C Instrucciones De Montaje página 8

8



1 Screws (2x)
2 Lock washer for safety pin
3 Cover for electrical connection




Changing the settings of B 120
With B 120 devices the increased current consumption of
the D 110 C brush head must be set in the system menu.






Note:
The parameters and menu structure are describe in the
service manual B 120.
3
-
EN
Slide the brush head under the appliance.
The rear clips are located above the swing arm.
Push the retaining clamp down and snap in place.
Secure the clip on the opposite side in the same way.
Push the brush head all the way to the back.
Align the holder to the centre of the elongated hole of
the lifting arm and tighten the screws.
Insert safety pin and install lock washer.
Ensure that the lock washer properly snaps into place
in the groove at the safety pin.
Replace cover.
Insert the red Intelligent Key.
Turn the programme selection switch to transport
mode.
Turn the I button until system parameter is displayed.
Search parameter IRegBKmaxD.
Increase value from 65A to 75A.
Leave the settings via the menu item EXIT.