Publicidad
Idiomas disponibles
Idiomas disponibles
ROUGH-IN ELECTRICAL
This hood is corded. A receptacle in the ceiling or wall is required. Incoming power
should be located as shown in Fig. 10 (top view) or Fig. 11 (front view).
.WARNING: Electrical.wiring.must.be.done.by.a.qualified.person.in.accor-
dance.with.all.applicable.codes.and.standards.
Wall
6" Duct
Ducted either Vertical or Horizontal.
Fig. 10.
INSTALL.THE.DUCTWORK.
DUCTED HOODS ONLY
CAUTION:.To.reduce.the.risk.of.fire,.
use.only.metal.ductwork.
1. This hood is configured for 6" duct.
2. Decide where the ductwork will run
between the hood and the outside.
Fig. 12.
3. A straight, short duct run will allow
the hood to perform most efficiently.
4. Long duct runs, elbows, and transi-
tions will reduce the performance of
the hood. Use as few of them as pos-
sible. Larger ducting may be required
for best performance with longer duct
runs.
5. Install a roof or wall cap. Connect
round metal ductwork to cap and
work back towards the hood loca-
tion. Use duct tape to seal the joints
between the ductwork sections.
Center Line
of Hood
4"
8"
Electrical
Box Location
FIG.. 10
- 9 -
Electrical
Box Location
Top of Hood
6" Duct
Electrical box location is not mounted
against ceiling. Fig. 11.
ROOF. CAP
ROUND
ELBOW
6"
DAMPER
HOOD
18-1/2".TO. 30-1/2".ABOVE
COOKING. SURFACE
(see."INSTALL. MOUNTING.
BRACKETS". section. for.
mounting. restrictions)
1/2"
4"
Center Line
of Hood
FIG.. 11
6-INCH
ROUND. DUCT
WALL
CAP
FIG.. 12
Publicidad
