Whirlpool LGC1330ADW Manual De Instalación página 6

Securing Sealed Burner on Cooktop to
Counter
1. Apply foam tape (foam tape is used on glass top
models only):
a. Remove the glass top unit from the carton and place
it upside down over two soft pads making sure
control knob does not interfere with any surface.
b. Peel off the backing paper from the foam gaskets
provided with the unit and stick the adhesive backed
tapes to the bottom edge of unit (see Detail A).
DETAIL "A"
2. Position cooktop in cutout.
3. From inside cabinet, position tie-down bracket
underneath cutout.
4. Attach with screws provided to small hole in bottom of
burner box bottom.
NOTE: Small hole may sometimes be partially covered
with enamel.
The mounting screws provided should be adequate for
most countertop thickness. If unusually thick countertop
is encountered a longer mounting screw can be used.
BOTTOM OF COOKTOP
FROM INSIDE CABINET
SEE
DETAIL
"A"
APPLY 1/2² X 1/2² FOAM GASKET
TO INSIDE OF 1/4² X 1/4² GASKET.
GASKET ENTIRE PERIMETER.
APPLY 1/4² X 1/4² FOAM GASKET
TO FLAT SURFACE OF GLASS.
GASKET ENTIRE PERIMETER.
CUTOUT IN
COUNTERTOP
TIE- - DOWN
BRACKET
LOCATION
ART #: C219-701
Installation
Mobile Homes
Check the cooktop model number plate to see if the
cooktop is approved for installation in mobile homes
and/or recreational vehicles. If approved the following
items are applicable.
The installation of a cooktop designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 [formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24 HUD (Part 280)] or,
when such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225.1/NFPA
501A, or with local codes.
In Canada the cooktop must be installed in accordance
with the current CSA Standard C22.1 - Canadian
Electrical Code Part 1 and Section Z240.4.1 - Installation
Requirements for Gas Burning Appliances in Mobile
Homes (CSA Standard CAN/CSA - Z240MH).
Recreational Vehicles
The installation of a cooktop designed for recreational
vehicles must conform with state or other codes or, in the
absence of such codes, with the Standard for
Recreational Vehicles, ANSI A119.2-latest edition.
In Canada the cooktop must be installed in accordance
with CAN/CSA - Z240.6.2 - Electrical Requirements for
R.V.'s (CSA Standard CAN/CSA - Z240 RV Series) and
Section Z240.4.2 - Installation Requirements for Propane
Appliances and Equipment in R.V.'s (CSA Standard
CAN/CSA - Z240 RV Series).
Clearance Dimensions
For complete information in regard to the installation and
clearances to combustible wall above the cooking top see
the installation drawings. For SAFETY CONSIDERA-
TIONS do not install a top section in any combustible
cabinetry which is not in accord with the installation
drawings.
Locating The Unit
It is best not to locate a cooktop near a window or in an
area subject to strong drafts. If you must locate it near a
window, choose an appropriate window treatment, one
that cannot blow over the unit and create a fire.
See installation drawings and special instructions for glass
top units.
For SAFETY CONSIDERATIONS make sure the cooktop
is secured to counter with tie down brackets and/or
screws provided and that the counter is level.
-6-