Whirlpool LGC1330ADW Manual De Instalación página 9

h. Apply a non-corrosive leak detection fluid to all joints
and fittings in the gas connection between the supply
line shut-off valve and the range. Include gas fittings
and joints in the range if connections were disturbed
during installation. Check for leaks! Bubbles appearing
around fittings and connections will indicate a leak. If a
leak appears, turn off supply line gas shut-off valve,
tighten connections, turn on the supply line gas shut off
valve, and retest for leaks.
NOTE: USE OF A MANOMETER TO CHECK FOR
GAS LEAKAGE IS ACCEPTABLE.
CAUTION: NEVER CHECK FOR LEAKS WITH A
FLAME.
WHEN LEAK CHECK IS COMPLETE, WIPE OFF ALL
RESIDUE.
i. Remove shipping wire
or screw from ALL top
burners. (Conven-
tional top burner
models only). This is
to hold the burners in
place on the burner
bracket for shipping
purposes only.
(See figure 1).
j. Adjust burner air shutter to the widest opening that will
not cause the flame to lift or blow off the burner when
cold.
NOTE: Correctly adjusted sealed burners, can have
flames that will lift or blow off without a pot over the
burner. These should be adjusted with a pot in place.
WARNING
Gas leaks may occur in your system and result in a
dangerous situation. Gas leaks may not be detected by
smell alone. Gas suppliers recommend you purchase
and install an UL approved gas detector. Install and use
in accordance with the manufacturer's instructions.
Checking Pressure Of House Piping
System
1. The appliance and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of 1/2 lbs./sq. in. (13.8 in. W.C.).
2. The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 lb./sq. in. (13.8 in. W.C.).
REMOVE
SHIPPING
SCREW
FIGURE 1
Removing Sealed Burner For
Adjustment Or Service
Mark ignitor location relative to main top with pencil. This
mark on the main top is used as a reference point when
replacing the burner assembly to insure that the burner
is tightened to its original position.
Rotate burner assembly approximately one-eighth turn
counter-clockwise and lift from main top (figure 3).
TO REASSEMBLE: Replace burner assembly in main
top and rotate approximately one-eighth turn clockwise
until burner locks into position with ignitor aligned with
reference mark on main top.
-9-
Regulator
All cooktops are equipped with a gas appliance pressure
regulator for controlling and maintaining a uniform gas
pressure in the gas manifold of the unit. The burner
orifices, etc., are sized for gas pressure delivered by the
APPLIANCE PRESSURE REGULATOR SUPPLIED. IT
MUST NOT BE REMOVED.
The gas appliance pres-
sure regulator for the top
section (see figure 2) is
located in the pack out
box for shipment. The
burner orifices, etc., are
sized for the gas pressure
delivered by the regulator
supplied - IT MUST BE
INSTALLED before
operating the top section.
For convenience of
service, it should be in-
stalled as shown in figure 2. The regulator must be
accessible for adjustment after installation.
ORIFICE HOOD
FIGURE 3
REAR OF UNIT
PRESSURE
REGULATOR
ARROW SHOWS
FLOW OF GAS
FIGURE 2