Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.4 - COUPLING TO TRANSMITTERS
Coupling of a channel to a transmitter
ON THE TRANSMITTER TO BE COUPLED activate the "Test" mode
the transmitter manual.
ON THE RECEIVER
LED 1
indicates the status of
Execute coupling according to the indication of the
described below.
A -
LED 1 off = channel not coupled
! Hold down
1
key
until a single acoustic signal sounds;
then release it:
LED 1
is flashing. The transmitter is coupled
to the receiver (fig. 7).
On the TRANSMITTER: deactivate "Test" mode.
B -
LED 1 flashing = channel already coupled to the transmitter
! To confirm coupling: deactivate
transmitter
! To cancel coupling: hold down
acoustic signal sounds; then release it:
On the TRANSMITTER: deactivate "Test" mode.
C -
LED 1 always on = channel coupled to another transmitter
! Hold down
1
key
until a single acoustic signal sounds; then
release it:
LED 1
is flashing (fig.9).The new transmitter is
coupled to the receiver.
On the TRANSMITTER: deactivate "Test" mode.
N.B.:
to replace a transmitter coupled to a channel, proceed as described in
Coupling the second transmitter to channel 2
Repeat all the operations described above, but using
(Wireless chronothermostat and/or thermostat)
(Ex.:
zone 1
chronothermostat to
channel 1
.
LED (A, B
or
C)
, as
"Test"
mode on the
1
key
until a single
LED 1
is off (fig. 8).
2
key
with relevant
channel 1
)
, as described in the chapter
"Coupling to receiver"
Fig. 7
1
2
Fig. 8
1
2
Fig. 9
1
2
1
2
Fig. 10
"C"
.
LED 2
(fig. 10).
in
E
N
1
2
2
s
1
2
2
s
1
2
2
s
1
2
2
s
11
Publicidad
Tabla de contenido
