Perry Electric 1TXRX02/P Datos Técnicos, Instrucciones Para El Instalador, Puesta En Funcionamiento Y Us página 14

2. - SIGNALING A TRANSMITTER MALFUNCTION 8
The receiver reports two types of transmitter anomalies:
E !
Failure to receive a radio signal for more than 30 minutes
!
N Transmitter battery almost dead.
In both cases, the signal is given by the intermittent, simultaneous lighting of the
ON and malfunctioning channel
ATTENTION: in the case of the lack of a radio signal, the control of the
corresponding solenoid valve
2. - DELETING A TRANSMITTER COUPLING 9
It is possible to delete a transmitter coupling even if it is not able to transmit the
!
1
Press and hold the
coupling is erased from the memory of the receiver and
ATTENTION: in the event the key is released before
the beginning of the long beep, the operation is
automatically cancelled and the command output is set
to "Temporary Forced" (see paragraph 2.3).
Press " RESET Key " to return to normal operation
3 0 . - RESET
The RESET command on the receiver cancels all the data stored in the
device except the coupling to
"Master" functioning.
!
Briefly press the " RESET key
light together with a beep
14
LEDs (ex.: fig.15 - channel 1 fault).
is also deactivated .
(even in a state of malfunction)
key until the end of the sequence of beeps shown in the figure
Fig. 16
the transmitter and the setting for
" : when it is released, all the
and the ON LED will be steady lit
FROM THE RECEIVER
Test signal (ex.: channel 1)
channel 1 is free.
1
6 s 4 s
When the key is released during this period of
time, the operation is cancelled
Fig. 17
RESET
LEDs will
(fig. 17) .
ON
1 2
Fig. 15
.
16 ; then let go. The transmitter
1
4
s
1 s 1 s 1 s
ON
2
s
1 2