ENGLISH
The manufacturer reserves the right to make all technical and manufacturing modifications deemed necessary without prior notice.
TECHNICAL SPECIFICATIONS
Supply voltage:
Device Absorption:
Type of action, disconnection and device:
Type of utput:
o
for solenoid valves
for pump or b
urner
Wire section at terminals:
Reception frequency
band
:
Maxi signal capacity in free air:
Maximum signal capacity in the presence of walls:
Signal reception mode:
Type of insulation:
Protection degree:
Pollution:
Operating temperature limits:
Storage temperature limits:
PERFORMANCE DATA
!
Possibility of
system operation with master chronothermostat
!
Pump
(or b
urner
)
activation
!
Coupling transmitters in self-learning mode, facilitated by luminous and audio signals.
!
It is possible to erase a transmitter coupling to the zone even in the event of transmitter failure.
!
Manually
forcing
the state of the output to test the system (5 minutes, resettable).
!
"RESET" command to erase temporary data in memory and deactivate commands.
!
Permanent, modifiable memory, for coupling the transmitter and assigning the Master.
!
Luminous signals indicating malfunctions due to the absence of transmission or an almost dead battery.
!
Highly reliable communications thanks to the
!
Lighted and/or audio signal, on 3 levels, of the TEST signal to verify the presence and capacity of the signal (VMETER)
230 V~ 50
2 5
. VA max
1/B/Electronic
2
relay
voltage-free - 5(2) A / 250 V~
1 relay
min. 1 mm ÷ max. 2.5 mm
"
868
-868.6"
120 m
30 m (according to the chap. 1.1 and to the chap. 1.4)
antenna internal to the receiver
Class II
IP30/wall-mounted
normal
-20 °C ÷ +70 °C
-25 °C ÷ +85 °C
in concomitance with the command for opening one or both solenoid valves.
double transmission of data
÷
60 Hz
s single-pole
changeover contact NO/NC/COM,
single-pole
contact NO/COM, voltage-free 5(2) A / 250
2
2
MHz
(see chronothermostat instructions - model with Master).
.
E
N
V~
3