How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation AIRE DELUXE Manual De Instrucciones

NOTE: This step is applicable after the neccessary wiring is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
Remove and discard the five rubber motor stops
1.
from the motor assembly by removing the screws.
(Figure 1)
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16˝-24 washer
head screws and fiber washers to secure the blade
to the blade holder. (Figure 2)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

How to Install Your Canopy Housing

WARNING

How to Assemble Your Ceiling Fan Blades

CAUTION
Blade Holder
HARDWARE USED:
3/16˝-24
WASHER HEAD
SCREWS
FIBER WASHER
10
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
3/16˝-24
Washer Head Screws
and Fiber Washer
(3 each per blade)
Figure 2
x 15
x 15
Blade