How To Install Your Canopy Housing; How To Assemble Your Light Kit - Fanimation AIRE DROP LP8068LAZ Manual Del Usuario

4. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
How to Wire Your Ceiling Fan (continued)
Installing Your Canopy Housing
WARNING

How to Assemble Your Light Kit

CAUTION
Hanger Bracket
Motor Assembly
12
Receiver
Figure 5
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1