Key Parts And Components; Installation Instructions; Choose The Proper Location; Clearances - LG WM0742H A Serie Guia Del Usuario

PA RT S A N D F E AT U R E S

kEY PARTS AND COMPONENTS

In addition to the special features and
components outlined in the Special Features
section, there are several other important
components that are referenced in this manual.
1 ULTRA-CAPACITY STAINLESS STEEL DRUM
The ultra-large stainless steel drum offers extreme
durability and is tilted to improve efficiency and
allow easier access for large items.
2 WATER CIRCULATION AND STEAM
NOzzLES
The water circulation nozzles spray the water/
detergent solution directly onto garments for
super cleaning performance. During LG's unique
high-efficiency STEAM cycles, the steam nozzle
injects fabrics with hot steam to gently remove
tough stains.
3 LEVELING FEET
Four leveling feet (two in the front and two in
the back) adjust to improve washer stability on
uneven floors.
DRAIN ACCESS PANEL
4
Provides access to the drain line and drain
pump filter.

4
3
Hot and Cold
Water Inlets
Drain
Hose
Rear of Washer
Included Accessories
Caps (4)
(for covering
Hot and Cold
shipping bolt holes)
Water Hoses
Wrench
Tie Strap
(for removing
Elbow Bracket
shipping bolts and (for securing
(for securing
adjusting leveling feet) drain hose)
drain hose)

CHOOSE THE PROPER LOCATION

wWARNING
• Washer is heavy! Two or more people
are required when moving and unpacking
the washer. Failure to do so can result in back
2
or other injury.
1
• Store and install the washer where it will not
be exposed to temperatures below freezing
or exposed to outdoor weather conditions.
Failure to follow this warning can cause serious
injury, fire, electrical shock, or death.
• Properly ground washer to conform with all
governing codes and ordinances. Failure to
follow this warning can cause serious injury, fire,
electrical shock, or death.
• To reduce the risk of electric shock, do not
install the washer in humid spaces. Failure to
follow this warning can cause serious injury, fire,
electrical shock, or death.
• The base opening must not be obstructed by
carpeting when the washer is installed on a
carpeted floor.

CLEARANCES

21
(54 cm)
To ensure sufficient clearance for water lines and
airflow, allow minimum clearances of at least
1 in. (2.5 cm) at the sides and 4 in. (10 cm)
behind the unit. Be sure to allow for wall, door,
or floor moldings that may increase the required
clearances.
I N S TA L L AT I O N I N S T R U C T I O N S
• Do not remove ground prong. Do not use
an adapter or extension cord. Plug into a
grounded 3-prong outlet. Failure to follow this
warning can cause serious injury, fire, electrical
shock, or death.
Power Outlet
• The power outlet must be within 60 in. (1.5 m) of
either side of the washer.
• The appliance and outlet must be positioned so
that the plug is easily accessible.
• Do not overload the outlet with more than one
appliance.
• The outlet must be grounded in accordance with
current wiring codes and regulations.
• Time-delay fuse or circuit breaker is
recommended.
NOTE: It is the personal responsibility and
obligation of the product owner to have a
proper outlet installed by a qualified electrician.
/ "
1
4
29 3 / " 4" 1"
4
(75.6 cm) (10 cm)
(2.5 cm)
51"
(129.5 cm)
Allow at least 24 in. (61.2 cm) in front of the
washer to open the door.
27" 1"
(68.6 cm) (2.5 cm)