Water Supply Connections; Hose Connection - Pfister SANTIAGO LF 49 Serie Instrucciones De Instalación

11
11G
11F
11D
11E
11A
11E
11F
11B
11A

11 HOSE CONNECTION

From underneath sink, push Center Connector (11A) onto receiving Tube (11B), until
unable to push any further. Pull down on Center Connector (11A). If the housing and
the Inner Collet (11C) separate slightly but do not pull off receiving Tube (11B), the
connection is secure.
To remove, push up on Center Connector (11A) holding plastic Collet (11C) in place,
pull down on Center Connector (11A) until Tube (11B) is free.
Slide the End Connectors (11D) with arrow (11E) pointing up onto the Valve Bodies (11F).
Push the End Connectors (11D) all the way up until completely seated. Be careful not
to damage O-Rings (11G).
11G
11B
11F
11D
11D
11B
11C
11C
ENGLISH
12
12D
12A
12B

12 WATER SUPPLY CONNECTIONS

First, thread Inlet Connectors (12A) into Water Supply Lines (12B). Then, insert Inlet
Connectors (12A) into Valve Bodies (12C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (12D) into
Valve Body Holes (12E), to secure unit.
WARNING: Do not twist Inlet Connectors (12A) once installed!
DRAIN BODY INSTALLATION
13
11B
11A
13 POP-UP INSTALLATION
Install and adjust Pop-Up (13A) using separate instructions supplied with the Pop-Up
assembly.
4
12C
HOT 12D
12D
12B
12E
13A
12C
12A
COLD