Service Address - Stop & Go 7 PLUS-MINUS SKT Instrucciones De Instalación

Prior to Function
Installation
EN
installation check
After installing the control device including the speaker housing, laying the high-voltage cable and attaching the stainless
steel contact plates, the setup should be retested to ensure that it functions correctly. Since the integrated sensor auto-
matically switches off the device if the vehicle is in use, you must ensure that the car is motionless before performing a
function check using a multimeter. Set "direct current –300 V" and measure the voltage between the two stainless steel
contact plates (should read 250–300 V). If the function check is successful but voltage fails to build up after installation,
an installation error has occurred.
Blinking at regular intervals (approx. every 5 seconds) = OK: ultrasound is being emitted, high voltage has built up.
Fast blinking = voltage is building up/dissipating. Caution: residual voltage!
LED off = device is switched off.
Prior to Function
Installation
installation check
1. Is the operating voltage (12 V plus and minus) of the car battery also present at the unit connections?
2. Is the engine switched off?
3. Have all the plus stainless steel contact plates been installed so that they do not touch any other live or
earthed parts (risk of short circuit)?
4. Is the device completely still and not subject to any movement or vibration?
5. Has the position of the stainless steel contact plates on the cable been changed, damaging the copper core?
6. No voltage detected on the stainless steel contact plate: Have the stainless steel contact plates been firmly
pressed into the base?
Prior to Function
Installation
installation check
Fuse box
12 V (+)
*Switching the device on and off
12 V (–) earth
Pull the slide contact (printed part)
half way out.
STOP&GO STOP&GO
10
Trouble Circuit
Warranty
shooting diagram
Trouble Circuit
Warranty
shooting diagram
Trouble Circuit
Warranty
shooting diagram
Function control light
Speaker housing
Control device/slide contact*
"click" instead of screw
0.5 A F
Plus plate (marked with a sticker)
Minus plate
Base
Fastening eyes/tunnel
Prior to Function Trouble
Installation
installation check shooting
IMPORTANT! Terms of the warranty (please keep in a safe place)!
Our 7 PLUS-MINUS SKT High-voltage device with ultrasound comes with a 48-month functional warranty.
1. Any reasonable complaints within the warranty period from the date of purchase will be remedied free of charge,
either through repair or delivery of a replacement product at our discretion. In order for the warranty to apply,
our product must have been properly installed and maintained in accordance with our installation instructions.
2. To enable us respond to problems, please return the complete unit, including the cable, stainless steel contact
plates and installation invoice, initially at your own expense. Once the problem has been resolved, the product
will be returned to you free of charge.
3. We are not liable for any further claims, such as costs for installing/deinstalling the unit. Any claim under Section
5 of our General Terms and Conditions shall remain unaffected, subject to the conditions set out therein.
4. Any damage caused by improper installation or incorrect, negligent or forceful operation shall invalidate the
warranty. There shall be no liability for consequential damage.
Technical changes and errors excepted.
Please fill in to claim against the warranty: For warranty claims to be processed, you must send us the filled in coupon
and the garage/installation invoice!
Garage stamp
Date of purchase
Technical support hotline
+49 (0) 7631 9727-80

Service address

Norbert Schaub GmbH
Robert-Koch-Strasse 20
79395 Neuenburg am Rhein
GERMANY
Tel. +49 (0) 7631 9727- 0
Fax +49 (0) 7631 9727-27
info@stop-go.de
www.stop-go.de
Circuit
Warranty
diagram
Unit serial number
EN
11