Electrical Connection; Imprint; Important Notice - Resol SP10 Instrucciones De Montaje Y Conexión

2. Electrical connection

1
1
2
2
Distributed by:

Important notice:

The texts and drawings in this manual are correct to the
best of our knowledge. As faults can never be excluded,
please note: Your own calculations and plans, under con-
sideration of the current standards and directions should
only be basis for your projects. We do not offer a guar-
an tee for the completeness of the drawings and texts of
this man ual - they only represent some examples. They can
only be used at your own risk. No liability is assumed for
in correct, incomplete or false information and / or the re-
sulting damages
Please note:
The design and the specifications can be changed without notice.
The illustrations may differ from the original product.
3
4
• Pierce the cable glands with a pointed object (fig. 1). Insert
the cables into the holes and pull them slightly back, such
that the edge of the gland is slightly turned to the outside.
Thus the device is protected against moisture.
• Connect the sensor cable to the terminals 1 and 2 with
either polarity (fig. 2).
• Connect the cable which leads to the controller at the
terminals 3 und 4 to the corresponding controller terminals.
Sensor cables carry safety extra low voltage (SELV) and
must not be placed in a gland together with cables carrying
230 V (US/CA: 115 V). If the connecting box is used out-
doors, it is recommended to pierce the condensation water
hole at the bottom after the device has been installed.
RESOL - Elektronische Regelungen GmbH
Heiskampstraße 10
45527 Hattingen / Germany
Tel.: +49 (0) 23 24 / 96 48 - 0
Fax: +49 (0) 23 24 / 96 48 - 755
www.resol.de
info@resol.de
Reprinting / copying
This mounting- and operation manual including all parts is
copyrighted. Another use outside the copyright requires
the approval of RESOL - Elektronische Regelungen GmbH.
This especially applies for copies, translations, micro films
and the storage into electronic systems.
Editor: RESOL - Elektronische Regelungen GmbH