Dash Disassembly - Metra 95-8720B Instrucciones De Instalación

1. Unclip and remove the switch plate
below the radio with the door locks
and hazard switch in it. (Figure A)
2. Remove the (3) T-20 Torx screws
exposed behind switch plate.
(Figure B)
3. Unclip and remove the trim plate
surrounding the factory radio.
(Figure C)
(Factory single DIN radio and
pocket shown, factory DDIN and
radio delete models may look
slightly different.)
Note: Pull down on the panel
that housed the switch plate to
ease in panel removal.
4. Depending on the factory radio
setup; remove the applicable
T-20 Torx screws and remove the
factory radio or radio blank plate.
Continue to kit assembly

Dash Disassembly

(Figure A)
95-8720B
(Figure B)
2
(Figure C)