Locomotive Functions; Function Switch; Information About Operating The Train - marklin 29199 Manual De Instrucciones

8. Locomotive Functions

• Recognition of the mode of operation: automatic.
• Addresses that can be set: 1 - 255
• Address set at the factory: 78
• Name set at the factory: Emma
• Headlights for the locomotive. They can be
turned on and off in digital operation.
• ABV — Adjustable acceleration/braking delay.
• Adjustable maximum speed.
• Setting the locomotive parameters (address, ac-
celeration/braking delay, maximum speed): with
the Control Unit, Mobile Station or Central Station.

8.1 Function Switch

The IR Controller can activate 5 digital functions
on the locomotives.
Controllable Functions:
Headlights
Locomotive operating sounds
Sound effect: Film excerpt
ABV, off
8.2 Controlling the Locomotive
Button on the IR Controller means Emergency
STOP
Stop. Current is turned off in the track with this
button (all locomotives come to a stop and all
functions are interrupted).
This button serves to prevent locomotive acci-
dents on the model railroad layout.
The Emergency Stop can be released again with
any other button.
The direction of the locomotive under control can
be changed with Button
This button also serves to stop the locomotive.
This button must then be pressed 2 times so that
the locomotive can continue to run in the same
direction.
The control knob for operating locomotives
always controls only the locomotive that has just
been selected with the address selector switch.
All other locomotives or powered rail cars con-
tinue to run at the speed last set for them.
= ^
3
2 4
1
+ +
0 0
- -
STOP
Function 1
Function 2
Function 4
on the IR Controller.
Important: When a new address is selected and
the control knob is already set at a speed position
(any speed position), the locomotive just selected
will immediately run at this speed. You must select
this locomotive address a second time, before you
can control the locomotive.
After you switch to a new address, it takes a
moment before the newly selected locomotive
can actually be controlled. This feature makes
it possible for you to skip over other addresses
when switching to a new address, without the
locomotives assigned to these addresses being
affected by the current setting for the control
knob. Control of the locomotive is assumed with
the last settings in use. The locomotive now
reacts to the controller.

9. Information about Operating the Train

9.1 Running 2 Trains
Only one switched mode power pack and one
Base Station may be used.
The switched mode power pack included with
the starter set provides power sufficient for a
maximum of 2 trains.
The locomotive to be controlled can be selected
with the switch on the controller (see Sections 7
and 8).
9.2 Removable Roof on the Locomotive
The roof on the locomotive can be removed to
install figures.
1.
15