User Maintenance; Care And Servicing Of Your Andis Trimmer Blades - Andis BTF Instrucciones De Uso Y Cuidado

FAILURE TO CHARGE:
1. Make sure voltage is present at the wall outlet (confirm with an appliance
you know is working).
2. Check to make sure adapter cord is plugged firmly into trimmer. Twist the
adapter connector slightly to ensure good electrical connection. If failure
to charge still exists, return trimmer to Andis or an Andis authorized
service station for examination and repair or replacement.
USE WITH ADAPTER CORD
If the trimmer powers off in the middle of a trimming job, the adapter cord
can be attached to continue use in corded operation. When the trimmer is
running with the adapter cord attached, the green light will remain off, even
if the battery is partially or fully discharged. The trimmer will not charge
while in use with the cord attached.
ATTACHMENT COMBS
(Comb sizes will vary by kit)
To attach combs, slide front of comb over the teeth of the blade (Figure C).
Snap comb down over back of blade until comb snaps into place (Figure D).
Combs help guide hair to cutting blades and give you precise control of
hair lengths. Each comb allows a different length of cut which is indicated
on the comb. Different blade angles in relation to the skin, thickness and
texture of the hair will vary the cutting length.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated at
the factory. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis
Company or an Andis authorized service station.

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES

Blades should be oiled before, during, and after each use. If your trimmer
blades leave streaks or slow down, it's a sure sign blades need oil. The
trimmer should be held in a position shown in Figure E to prevent oil from
getting into motor. Place a few drops of Andis Clipper Oil on the front and
side of the cutter blades (Figure F). Wipe excess oil off blades with a soft
dry cloth. Spray lubricants contain insufficient oil for good lubrication, but
are an excellent clipper coolant. Always replace broken or nicked blades to
prevent injury. You can clean the excess hair from your blades by using a
small brush or worn out toothbrush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus while
the trimmer is running. Any excess hair and dirt that has accumulated
5