Good Earth Lighting SE1216-BRS-02LF4-G Manual De Instrucciones

Light head
Tête de la lampe
Cabeza de luz
Motion Sensor
Détecteur de mouvement
Sensor de movimiento
1. LEDs can be damaged by electrostatic discharge (ESD) shock. Before installation, discharge yourself by touching a grounded bare metal surface
to remove this hazard. To avoid damage, do not remove the clear lens over the LED module.
2. NOT FOR EAVE MOUNTING ONTO PERFORATED EAVE MATERIAL. Doing so can allow water to seep into the fixture canopy.
ASSEMBLY INSTRUCTIONS
Remove the mounting plate by turning counterclockwise until it comes loose.
Locate the open holes for mounting at the midline of the mounting plate and drill a pilot hole in the center. If mounting onto brick or masonry, drill 3/16 in. hole and place the masonry anchors (AA) in
the pilot holes and hammer them into place until flushed with surface of masonry. Drive long screws (BB) into masonry anchor until snug. DO NOT OVERTIGHTEN. If mounting onto wood surface, use
the wood screws (BB) provided to secure the mounting plate.
OFF ON OFF ON
Remove the screw on the battery compartment cover. Remove the battery compartment cover.
Insert 3 new alkaline C cell batteries (not included) into the battery compartment and orient them with the "+" and "-" markings on the back of the battery compartment. Re-attach the
battery compartment cover by aligning the legs on the lower edge of the battery compartment cover onto the fixture body and close the cover until the catch at the top engages. Re-attach
the screw. When ready to use, turn the switch, located below the battery compartment, to "ON". There will be an approximate 15 second delay for the fixture to light up, even if there is
motion. This will occur every time the fixture is turned "OFF" and back "ON" at the switch or the batteries are changed. Do not mix old and new batteries. Cold weather may have a
negative impact on battery life.
Attach the security light to the mounting plate by positioning the security light over the mounting plate at an angle. Engage the security light into the grooves of the mounting base and
secure by twisting clockwise until the security light is seated vertically.
LIGHT ORIENTATION
WARNINGS AND CAUTIONS
AA
x2
BB
x2
C
BATTERY REPLACEMENT
The individual light
heads can be
adjusted up/down
and left/right to aim
the light heads in
the direction
desired.
Éclairage de sécurité à DEL activé par un mouvement et alimenté par piles (Page 2)
Luz de seguridad LED activada por movimiento y alimentada por baterías (Página 4)
Mounting base
Hardware kit*/ Kit de petit matériel de fixation* / Kit de aditamentos*
Base de montage
AA
Base de montaje
x2
* Actual hardware may differ from illustration
* Les éléments de fixation réels peuvent être différents de ceux de l'illustration.
* Es posible que los herrajes reales difieran de los de la ilustración.
Required
Nécessaire
Se necesita
MASONRY
3/16 in.
0,48 cm
Masonry bit
OFF
OFF
C C
LED Motion-Activated Battery Operated Security Light(Page 1)
Model / Model / Modelo #: SE1216-BRS-02LF4-G
BB
x2
1/16 in.
0,16 cm
WOOD
1/16 in.
0,16 cm
ON ON
3/16 in.
0,48 cm
OPEN LOCK
UPWARD
Low battery warning light (red glow
inside the PIR) only stays on for 30
minutes. Use ONLY Alkaline batteries
for replacement.
Remove the mounting base by turning
counterclockwise until it comes loose.