Fcc Caution - Project Source 19551-000 Manual Del Usuario

FCC CAUTION

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment on
and off, the user isencouraged to try to correct the interference by one or more of the following:
Reorient or relocate the receiving antenna.
Increase the separation between the lighting unit and receiver.
Connect the lighting unit into an outlet on a circuit other than the outlet which the receiver is
connected. Consult the dealer or an experienced radio/TV technician for assistance.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly Time: 45 minutes
Tools Required for Assembly (not included): Wire stripper, Phillips screwdriver, Electrical tape, Drill,
7/32 in. drill bit, 5/8 in. drill bit, Measuring tape, Ladder and Pencil.
Helpful tools (not included): Gloves
ASSEMBLY INSTRUCTIONS
1. Remove the canopy screws (E) from the canopy (D)
to expose the mounting plate (B). Loosen the
track mounting screws (A) preassembled to the
mounting plate (B). Note: Do not remove the track
mounting screws (A) completely.
2. Connect the wires (white wires from connector
to the white wires from the supply circuit, black
wires from the connector to the black wires from the
supply circuit, and the green ground wire from the
power supply to the ground wire of the supply circuit)
using the wire connectors (DD). Wrap electircal tape
(not included) around wire connectors (DD) and be
sure they are secure. Push all excess wire and
wire connectors (DD) back into the outlet box
(not included).
Hardware Used
DD
Wire Connector
x 3
4
1
A
D
2
DD
Lowes.com
B
E
Outlet Box