Project Source 19551-000 Manual Del Usuario página 7

7. Tighten the track mounting screws (A) to secure
the track section (F) to the mounting plate (B).
8. Twist the power supply (C) into the track
section (F). Secure the canopy (D) to the
mounting plate (B) by tightening the previously
removed canopy screws (E).
Note: When the power supply (C) is twisted
into position on the track section (F), make sure
the two copper tabs on the side of the power supply
(C) align with the two copper strips inside
the track section (F). This is necessary to
maintain polarity.
9. Identify ground side on the track head (G) connector
and track section (F).
Push the top portion of the track head (G) connector
into the slot of the track section (F). Pull down the
connector's locking tab. Twist ground side of the
track head (G) connector toward the ground side
the track section (F) until the track head (G)
connector snaps into place.
NOTE: The ground side of the track head (G)
connector is the side with two metal tabs. The
ground side of the track section (F) has an indented
groove on the face and two internal copper strips.
The track head (G) can only be assembled if the
ground sides of the track head (G) connector and
the track section (F) are aligned.
7
B
B
F
F
8
B
E
9
GROUND
TAB
GROUND SIDE OF
CONNECTOR
G
7
A
A
C
D
F
GROUND GROOVE
Lowes.com
F