Loading a .PKG file
The following procedure allows you to load the Operating Sys-
tem and/or the Musical Resources supplied as ".PKG" files. As an
example,
we
will
load
"Pa800_os_v[nnn].pkg", where [nnn] is the version number).
1.
Copy the file "Pa800_os_v[nnn].pkg" to an USB storage
device (like an USB pen or an external USB hard disk).
As an alternative, you can copy the file to the internal hard
disk of the Pa800 (if installed), by using the USB Device
port to connect your Pa800 to a personal computer.
2.
Turn the Pa800 off, and connect the USB device to one of
Pa800's USB Host connectors – either the Front [USB-F] or
Rear [USB-R] port.
3.
Turn the Pa800 on, while keeping the INTRO 1 button
pressed.
4.
A file browser will appear in the display:
At this point, you can release the INTRO 1 button.
5.
From the Device Selector, choose the device where you
copied the Operating System. For example, if it was a USB
pen drive connected to the front USB port, choose USB-F:
Note: If you are not able to easily select the file, please press
the GLOBAL button to open the Touch Panel Calibration
page, and re-calibrate the display.
Loading Pa800's Operating System and Musical Resources
the
Operating
System
(file
6.
Browse through the folders and files, until you find the
"Pa800_os_v[nnn].pkg" file. When you find it, touch it and
press the Select button in the display:
7.
The file begins to be copied in the Operating System area
inside the instrument. A progress bar will show the copy
advancement:
Warning: Do not power the instrument off, or remove the
USB device, while this procedure is running!
Note: Loading the "Pa800_os_res_v[nnn].pkg" files may take
up to 10 minutes.
8.
At the end of the procedure, press the OK button in the dis-
play to restart the instrument:
3
Loading a .PKG file