Step 1. Measure Cabinet Opening - Monogram ZWE23PSNBSS Instrucciones De Instalación

WARNING
Built-in style models (ZWE) are top heavy, especially with
any doors open. These models must be secured with
the anti-tip floor bracket to prevent tipping forward, which
could result in death or serious injury. Read and follow
the entire installation instructions for installing the anti-tip
floor bracket packed with your refrigerator.
AVERTISSEMENT
Risque de basculement
Les modèles encastrés (ZWE) sont plus lourds au niveau de leur
partie supérieure, surtout avec les portes ouvertes. Ces modèles
doivent être fixés à l'aide du système anti-basculement par fixation
au sol pour éviter que l'appareil ne bascule vers l'avant, ce qui
pourrait entraîner des blessures graves, voire mortelles. Lisez et
suivez les instructions d'installation complètes pour l'installation
du système anti-basculement par fixation au sol livré avec votre
réfrigérateur.
ADVERTENCIA
Los modelos con estilo incorporado (ZWE) son inestables,
especialmente con las puertas abiertas. Estos modelos deben
ser asegurados con el soporte antivolcaduras, a fin de evitar
caídas hacia adelante, que podrían resultar en la muerte o
lesiones graves. Lea y siga las instrucciones de instalación en
su totalidad, a fin de instalar el soporte de piso antivolcaduras
embalado con su refrigerador.
STEP 1 MEASURE CABINET
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where refrigerator
will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
Width, W, should not be less than 36 inches. The
refrigerator will be placed approximately in the middle
of this opening.
Rear Wall
W
REFRIGERATOR
Front
31-49161 Rev. 2
Installation Instructions
Tip Over Hazard.
Riesgo de Caídas
Baseboard
Thickness
or Countertop
Overhang
(Whichever
is Greater) Plus
Any Desired
Clearance
RH Side
STEP 2 LOCATE ANTI-TIP
BRACKET
A. Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor up
against the rear wall, within W, and in line with the
Figure 1 – Installation Overview
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
desired location of the RH side of the refrigerator
(see Figure 1).
B. Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
approximately 15-1/4" (38.74 cm) from the edge of
the sheet or the RH side of the refrigerator.
C. Hold down in position and use the anti-tip floor
bracket as a template for marking the holes based
upon your configuration and type of construction
as shown in Step 3. Mark the hole locations with a
pencil, nail or awl.
NOTE:
It is REQUIRED to use at least 2 screws
to mount the floor bracket (one on each side of the
anti-tip floor bracket). Both must be into either the
wall or the floor. Figure 2 indicates all the acceptable
mounting configurations for screws. Identify the
screw holes on the anti-tip floor bracket for your
configuration.
2 Wall Holes
Floor Bracket
to Install
RH Holes
15 ¼"
Rear RH
Corner of
Cabinet Wall
RH Side of
Locator
Refrigerator
Template Sheet
7