Sunbeam Touch & Go 3890 Manual De Usuario página 16

2.
Fill the water reservoir with tap water (10
ounces) and close the water reservoir cover.
3.
Set the Fabric Select dial to Linen.
4.
Plug the iron into a power outlet and allow the
iron to heat for 2 minutes.
5. Turn the Steam control and the Fabric Select
dial to OFF and unplug the iron.
6.
Hold the iron over a sink in a horizontal
position.
WARNING: Be careful not to touch the iron's hot
surfaces.
7.
Turn the Steam control to CLEAN. Water will
begin dripping from the steam vents. To make
sure that all of the water is removed from the
tank, slowly rock the iron side to side and front
to back for 30 seconds. When rocking the iron,
dip the nose of the iron slightly below the rear
of the iron to make certain the water circulates
completely.
13