Ironing; Dry Ironing; Steam Ironing - Sunbeam Touch & Go 3890 Manual De Usuario

Ironing

Dry ironing

1.
Make sure that the Steam control is set to OFF.
2. Plug the cord into a 120 volt AC outlet.
The Power Indicator will light.
3. Turn the Fabric Select dial to the Dry ironing
fabric setting you desire (Silk or Synthetics) and
allow the iron to heat for 2 minutes. While the
iron is heating, make sure it is sitting on its heel
rest on a stable, protected surface.
Tip: Refer to the Ironing guide on page 16 for
the recommended setting for your fabric.

Steam ironing

Follow the instructions for "Filling the water
reservoir" on page 5.
Plug the cord into a 120 volt AC outlet.
The Power Indicator will light.
Turn the Fabric Select dial to the Steam ironing
fabric setting you desire (Linen, Cotton or
Wool) and allow the iron to heat for 2 minutes.
While the iron is heating, make sure it is sitting
on its heel rest on a stable, protected surface.
Tip: Refer to the Ironing guide on page 16 for
the recommended setting for your fabric.
After the iron has heated (2 minutes), turn the
Steam control to ON.