Dri-Eaz TurboDryers Sahara E Manual Del Propietário página 3

Important Safety Instructions: Always disconnect the
TurboDryer from its power source before performing
any maintenance or cleaning.
T C
O LEAN INTERIOR
To remove grill and blower wheel:
1. Use a Phillips #2 screwdriver to remove 2 screws.
.
2. Remove inlet grill
3. Loosen the blower wheel shaft nut (3/8" socket driver)
Note the backstop for ensuring alignment when replac-
ing wheel.
4. Pull the blower wheel out of the unit.
5
6
To reassemble unit:
Follow the steps above in reverse order (starting with #9).
Note: Before tightening shaft nut on wheel, ensure that bolt is aligned with flat
spot on shaft (see photo A).
07-01534 Copyright 2006 Dri-Eaz Products, Inc.
( ):
AS NEEDED
2 3
To remove control panel and motor:
Rotate the unit onto its side so that the controls are facing up.
5. Unscrew 2 screws securing cord guard (#2 Phillips screwdriver).
6. Remove cord guard.
7. Remove 4 motor mount bolts with 3/8" nutdriver.
8. Pull motor assembly out of the housing.
7
.
1
4
3
8
A