Publicidad
Idiomas disponibles
Idiomas disponibles
6. Initial use
1.
Take the device out of the package and remove all the packaging material.
Place the humidifier before initial use on a flat and even surface.
2.
Remove the water tank from the device. Turn over the water tank and open
the tank cover.
3.
Fill the tank with clear water. Ensure that the water temperature is not
above 40 °C.
4.
Then place the glass lid over the atomiser unit.
5.
Now screw the water tank cover back onto the tank properly.
6.
Afterwards, put the water tank back onto the base unit. Ensure that the tank
is firmly seated and does not wobble.
7.
Then, the cover should be placed with the steam outlet on the top of the
tank. The steam outlet can be rotated as required.
8.
By pressing the key illumination (night light), the key illumination of the po-
tentiometer can be switched on or off.
9.
Then, the power cable of the diffuser can be connected to a properly in-
stalled power outlet. The device is now ready to be used. To start, turn the
ON / OFF / Release potentiometer into the direction of "ON". The quantity of
steam released can be set individually in this potentiometer. Rotate the po-
tentiometer clockwise to increase the released quantity and anticlockwise
to reduce the released quantity.
7. Signal-LEDs
A signal LED is located in the base unit. If it lights up red, then the automatic
shutdown is switched on. In this case, refill the water tank.
If the signal LED lights up blue, then the device is active.
14
English
Publicidad
