Equipment Description - Sagola COMPACT 220 Manual De Instrucciones

The COMPACT 220 is manufactured entirely of AISI
304 stainless steel. Basically is composed of an
upper tank that is used for automatic washing machi-
ne parts, containing a grill work (no.1 Figure 1) on
which can be placed spray guns and accessories for
cleaning.
Inside the tank, there are several spray jets (no.2
Figure 1) for the interior and exterior cleaning of the
spray gun automatically.
Also equipped pneumatic connectors to feet two tires
in the air inlet of the spray gun and prevent solvent
into the gun during automatic washing (no.3 Figure 1).
Fig. 2
4
The inner tank includes a vapor outlet connected to a
automatic extraction (No.4 Figure 2) and two anchors
trigger (No.5 figure 2) to maintain the spray guns
open during cleaning.
The lower zone is designed to introduce two contai-
ners of solvent for recirculating and clean solvent, the
total amount introduced of these two solvents should
not exceed the total capacity of the recirculation tank
to prevent overflow.
This lower area has two absorptions, one with inlet
filter (No.6 Figure 3) to be introduced in the solvent
tank for recirculating it through a diaphragm pump
(No.9 Figure 3) allows a second use.
The other absorption (No.7 Figure 3) will be introdu-
ced into the clean solvent tank. This absorption of
clean solvent is for automatic cleaning (through the
diaphragm pump) either a timed way or manually by
a pushbutton. In each case the clean solvent will
return to the tank through the drain (No.8 Figure 3).
5. DESCRIPCIÓN DEL EQUIPO
5
- 14 -
Fig. 1
1
3
CLASSIFICATION ACCORDING TO THE ATEX
DIRECTIVE
The machine conforms to the essential requisites of
the EU Directive 2014/34/UE, better known as ATEX
("Explosive atmospheres"). It is classified as group II
category 3 letter G system. The assessment proce-
dures of conformity, carried out by an internal factory
check, allow the installation of the machine in
surroundings where there may be potentially explosi-
ve atmospheres due to the presence of gas, fumes or
mist.
Preparation for extraction of fumes.
For the compliance ATEX, the machine is equipped
with a system of forced evacuation of the fumes
generated during the operation.
2
8
Fig. 3
4
6
7