Kemper PROFILER Guía Rápida página 8

8 PROFILER REMOTE
Rig buttons 1-5
These are the buttons for selecting Slots in Performance Mode, and Rigs in Browse Mode.
TAP button
This button triggers the TAP tempo, just like the TAP button on the front panel of the Profiler. Tap in quarter
notes to adjust the tempo of delay, phaser, flanger, and tremolo effects. The LED will blink to indicate the current
tempo. Hold this button while you play to activate our marvelous Beat Scanner, which calculates the tempo ac-
cording to the rhythm and pattern of your playing. You can read more about this function in the "Tempo" chapter
in the Reference Manual.
TUNER button
Use this to activate Tuner Mode. If the parameter "Mute Signal" is activated, your guitar will be muted while you
tune it.
Effect buttons I-IIII
These four buttons can be freely assigned to switch stomps and effects on/off. They can also be used to toggle
features in certain effects. Their respective assignments are stored per Rig. Each button can be assigned to sev-
eral stomps and effects, if you wish.
The first and second assignments are indicated by the four LEDs around each effect button. The color LEDs in
the upper row reflect the category of stomp/effect, just like the color LEDs on the Profiler's front panel. They re-
main unlit, if no effect has been assigned. The LEDs in the lower row indicate whether the respective effect is on
or off, just like the corresponding stomp and effect buttons on the Profiler's panel. If three or more effects are as-
signed to the same Effect Button within a particular Rig, only the first two effects are visualized by these LEDs.
Assigning switching functions to the Effect Buttons is simple: just press and hold an Effect Button and press
the desired Module Button, e.g. STOMP A, on the Profiler's front panel at the same time. Done! It also works the
other way round: press and hold the Module Button on the Profiler first, then step on the desired Effect Button