Thermo Scientific Cimarec SP88857100 Manual De Funcionamiento Y Lista De Piezas página 6

S I
AFETY NFORMATION
To avoid personal injury:
1.Do not use in the presence of flammable or
combustible materials — fire or explosion may
result. This device contains components which may
ignite such materials. Not rated for use in hazardous
atmospheres.
2.Use caution when heating volatile materials; top
surface and element can reach the "Flash Point
Temperature" of many chemicals. These hot plates
are not explosion proof. Fire or explosion may result.
Unit contains components which may ignite such
materials.
3.Keep top surface clean. Use a non-abrasive cleaner.
Alkali spills, hydrofluoric acid spills or phosphoric acid
spills may damage top and lead to thermal failure.
Unplug unit and remove spills promptly. Do not
immerse unit for cleaning.
4.Replace the top immediately if damaged by etching,
scratching or chipping. A damaged top can break in
use.
5.Do not use metal foil on hot plate which may block air
flow. Overheating will result.
6.Check and tighten the removable cord periodically
making sure it is secure. If loosened, the cord
could become hot and/or spark and be a potential
fire hazard. If cord appears damaged, replace
immediately. If cord is repeatedly loosened it is
recommended to purchase the power entry module
(part number CIC0000793 or CIC0000469 depend
on models) listed in the Replacement Parts section of
this manual.
6
7.Do not remove or modify grounded power plug. Use
only properly grounded outlets to avoid shock hazard.
8.Use appropriate hand and eye protection when
handling hazardous chemicals.
9.Gross weight of items placed on top of hot plates
should not exceed 35 lbs. (15.9 kg.) on the 10" x 10"
models, 25 lbs. (11.3 kg) on the 7" x 7" models and 15
lbs. (6.8 kg) on the 4" x 4" models.
10."Caution: Hot Top. Avoid Contact." The top plate of
the unit can remain hot for some time after use. A
"CAUTION - HOT TOP" light will remain on until top
plate temperature cools to below 50°C.
11.Do not leave an active probe out of the fluid. This
may cause uncontrolled heating of the fluid on the hot
plate and unintentional boiling or an explosion could
occur.
12.Localized heater element temperature can be
significantly higher than the temperature indicated on
the display. If flammable concentrations reach internal
element, a fire could result.
13.Note that the exterior housing will be hot during and
for a period of time after use.
14.Refer servicing to qualified personnel.