Maintenance; Daily, By A Trained Operator; Every 25,000 Loaves And/Or At Least Once A Year, By An Approved Agent; Blade Replacement - JAC Full 520 T2 Manual Del Usuario

Press the white button to operate the blower (fig.7) (FLD).
At the end of the day, press one of the red emergency stop buttons (fig.4, n°25) to switch the power
off to the machine.
Tip: Have a qualified individual check blade tension after the first few days of operation.
Capacity: Number of loaves sliced per hour: 1,000 (depending on the type of bread).
Max. loaf size (L x H) (cm): 52 x 16
Min. loaf size (L x H) (cm): 12 x 6
8

MAINTENANCE

8.1

Daily, by a trained operator.

A. Check whether you need to empty the crumb trays.
B. Clean the table and the ramp using a brush.
C. Use a dry cloth to clean the inside.
D. Use a damp cloth to clean the outside.
E. Clean the belts with a damp cloth.
8.2

Every 25,000 loaves and/or at least once a year, by an approved agent.

A. Remove the plug from the socket.
B. Check the condition of the cutting blades.
C. If you notice a deterioration in cutting quality, the cutting blades must be replaced (JAC part
number: 6110019 in the JAC Spare Parts catalogue).
D. If the blades need to be replaced, do so in accordance with the blade replacement procedure
(§8.3).
NB: Do not overtighten the blades, as this risks distorting the frames.
E. Sweep and vacuum the inside of the machine.
F. Check bearing condition, then lubricate them.
Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
8.3

Blade replacement.

(fig.8,9)
Always wear cut-resistant gloves (EN 388:2003 version B= 5) and safety footwear when replacing
blades or when working in the vicinity of blades.
Having ensured that the plug on your machine has been disconnected from the mains:
A. Remove the screw securing the bagger. Repeat this on machines with two baggers (FMD).
B. Remove the 2 screws securing the cover.
C. Open the cover. Remove the 4 screws securing the front table (FLD). If your machine is fitted
with an outfeed belt (FMD), remove the 8 screws securing the belt.
D. Remove the table (FLD) or the outfeed belt and disconnect its connection (FMD).
E. On the upper part of the front frame, remove screws A, which secure the frame to the
polypropylene strips (never remove the strips from the frame, as you risk altering factory
settings).
English
12