Installation And Commissioning; Unpacking The Machine; Positioning; Electrical Connection - JAC Full 520 T2 Manual Del Usuario

5

INSTALLATION AND COMMISSIONING

5.1

Unpacking the machine:

Machines are delivered from our works on pallets, strapped and protected with a wooden crate. First
of all, the packaging must be examined and any damage caused in transit must be declared directly
to the carrier.
A. Remove the wooden crate and the packaging bag from the machine. If your machine is
equipped with a loading ramp (optional), remove it from on top of the machine and unpack it.
B. Remove straps, taking particular care when they are released by cutting.
C. Detach the machine from its pallet by removing the wooden battens wedging the castors.
D. Take the machine off the pallet. Make sure you do this with at least two people in order to
lower it as gently as possible onto the floor.
E. Please fit the adjustable bagger stop to the bagger (fig.11, n°34).
F. Fit the (optional) loading ramp if the machine is equipped with one (fig.12).
After unpacking your machine, check that it has not been damaged in transit. Notify
us of any defects.
5.2

Positioning:

In order to achieve excellent performance and long-term reliability, choose a location that is:
Well ventilated, shielded from direct sunlight and away from sources of heat, with a flat and
sturdy surface free from vibration.
5.3

Electrical connection:

IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
Your mains electricity supply to the machine must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16 A protection.
For machines equipped with a variable speed drive, it is imperative that they be connected to a
junction box on a circuit fitted with a 300 mA RCD.
Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting your machine to the mains supply and in order to prevent the motor from burning
out when it is switched on, it is important to check that the mains supply matches the machine
specification (see machine nameplate).
9
English