Preparing The Microscope For Use; Working With The Microscope - Euromex BioBlue Serie Manual Usuario

4.7 Illumination EUROMEX BioBlue serie
The LED illumination of the BioBlue is equipped with rechargeable batteries.
The length of use after charging is about 60 hours. The full charging time is about 10 hours. At
First use the batteries have to be fully charged. Connect the cable to the mains socket.
The illumination has the following specifications:

LED : 1W, 300 mA.

Charger : Primary AC 100 - 240 Volt-50/60Hz.

Batteries : 3 NiMh, AA type, 1.2 Volt 1600 - 2600 mA.

5.0 Preparing the microscope for use

Remove the packing and put the microscope on a flat table. The objectives are pre mounted.
Put the plug into the mains supply and switch on the microscope . Sit comfortably down behind the
microscope and take a relaxed position while viewing through the eyepieces (O).

6.0 Working with the microscope

Please read the following instructions to achieve the best microscope observing results.
6.1 Setting the interpupillary- and diopter distance (binocular type)
Using a binocular tube is less tiring for the eyes than the use of a monocular tube. In order to
obtain a smooth "compound" image as well as the right interpupillary setting, one should go
through the below steps.
 Set the right interpupillary distance by moving the eyepieces towards or away from each
other until a compound field of view is achieved (see drawing above).
 Close the left side eye and focus looking through the right side eye with the coarse-and fine
adjustment knobs (I)
 Now close the right side eye and focus the left side tube by means of the dioptric
adjustment ring (B).
This procedure should be followed by each individual user.
Field of view before
adjustment
6
Field of view after
adjustment