Installation Notes; Lamp Replacement - Designers Edge HEAT ZONE H-12000 Manual Del Usuario

1. Disconnect power before installation and when re-lamping.
2. If you are unfamiliar with installing electrical fixtures contact a qualified
3. Securely fasten mounting bracket to the fixture.
4. Do not attempt to relocate fixture when hot.
5. Minimum distance from side wall is 5'
6. Keep out of reach of children.
1. Disconnect power supply and make sure lamp and fixture are not hot.
2. Unscrew the screws at the top of the housing.
3. Open hinged cover, remove the lamp by pushing one end into it's
holder and pulling the other end towards you.
WARNING: Do not handle lamp with your bare hands as the oil from
your hands will cause premature failure of the lamp.
CAUTION, before using this appliance:
Check that the voltage indicated on the type plate
corresponds to the mains supply voltage.
• Ensure that the heater has been securely fastened
• Unplug and turn off power switch during
• Do not handle the halogen heat emitter with
• Do not use an extension cable with this product.
• Keep the power cable away from the body of the heater as it will get hot
• Ensure that children do not tamper with the heater.
• Do not insert any object through any slot or opening in the heater.
H-12000_inst.indd 4

Installation Notes

electrician to install

Lamp Replacement

in its final mounting position.
installation, cleaning and/or replacing the
emitter. Always ensure that the emitter is cool.
bare hands.
during use.
5/20/08 9:37:08 AM