Designers Edge HEAT ZONE H-12000 Manual Del Usuario página 7

Keep out of reach of children.
MAINTENANCE
In the event of heater failure please contact the retailer first. For
spare parts and advice, please contact the manufacturer.
Disconnect the power before commencing any maintenance procedure including
cleaning.
To ensure optimal heat effectiveness, it is
recommended that after the heater has been
used approximately 80-100 hours, the front glass and the reflector are wiped with
a lint-free cloth.
The heater is supplied with safety glass. In the
unlikely event that it should become cracked,
please contact the manufacturer for an immediate replacement.
REPLACING THE EMITTER
• Turn fixture off and unplug to ensure that the heat emitter is not illuminated
and that the heater body and emitter are cool.
• Unscrew the back two screws at the top of the casing.
• Open the hinged front cover.
• Remove the heat emitter from the spring loaded holders by pushing one end
further into its holder and pulling the end that is free towards you.
• Refit in reverse order.
CAUTION: Do not handle the heat emitter
with bare hands. Finger marks will burn into
the quartz emitter causing premature emitter failure.
H-12000_inst.indd 7 5/20/08 9:37:16 AM