Kohler K-158 Guia De Instalacion página 3

Spout
Escutcheon
Sink
Washer
Shank Nut
Handspray
Hose
1. Install the Spout and Handspray
NOTE: Before applying plumbers putty or other sealant to the
escutcheon, make sure the O-ring is in place in the groove on the
interior surface.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheon according to the manufacturer's instructions.
Thread the shank nut and washer to the bottom of the shank.
Insert the shank from the bottom of the sink.
Slide the escutcheon over the shank.
Thread the spout to the bottom of the shank, then loosen the
spout 1/8 of a turn.
Loosen the shank 1/8 of a turn.
IMPORTANT! Do not loosen the shank more than 1/2 turn. The
spout may not seal, resulting in a leak.
Tighten the nut and washer to secure the spray holder to the sink.
Slide the gasket (provided) onto the spray holder.
Slide the spray holder through the mounting hole from above.
Securely hand tighten the nut to the spray holder from under the
sink.
Insert the handspray hose through the spray holder.
Attach the handspray hose to the shank tee using thread sealant.
Kohler Co.
Handspray
Spray Holder
O-Ring
Nut
Apply
plumbers
Shank
putty.
Shank Tee
3 1015072-2-D