GEARSTONE CS-WP7 Manual Del Usuario página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 73
14 Product Maintenance
1. After lubricating the running belt for a period of time, it must be lubricated with a
specially configured methyl silicone oil. Suggest:
Use time less than 3 hours per week; lubricate once every 5 months
Use 4~7 hours per week; lubricate once every 2 months
Weekly use time is more than 7 hours; 1 month lubrication 1 time
Do not over lubricate, the more lubricant is not the better.
Note: Reasonable lubrication is an important factor to improve the service life of the
treadmill.
2. To check whether you need to apply lubricant again, just grab the running belt and
touch your hand to the center of the back of the running belt as much as possible. If
your hand is stained with silicone (somewhat moist) ), which means that no more
lubricant is needed. If the running board is dry and there is no methyl silicone oil
sticking to your hand, you need to add lubricant.
Steps to apply lubricant to the running board: (as shown in the picture on the right)
stop the running belt and fold the machine; lift up the running belt at the bottom of the
main engine; extend the oil can into the middle of the running belt as much as possible,
and apply methyl silicone oil Spray on the inner side of the running belt and apply
methyl silicone oil on both sides of the running belt; run the treadmill at a speed of
1km/H to evenly apply the methyl silicone oil, and lightly step on the running belt from
left to right for about a few minutes The methyl silicone oil can be completely absorbed
by the running belt.
3. Adjusting the tightness of the running belt. All treadmills must be adjusted to the
running belt before and after installation. However, there may be slack after a period of
use. For example: the user pauses and slips when running. When this phenomenon
occurs, adjust the walking belt adjustment bolts in a clockwise
4. Running belt deviation adjustment
All treadmills must be adjusted before delivery and after installation. However, after a
period of use, they may still run off the track. The reasons for this phenomenon are as
follows:
① The host is not stable.
② The user's feet are not in the middle of the running belt when exercising.
③ The user's feet are unevenly used.

Publicidad

Tabla de contenido
loading

Tabla de contenido