Angle Adjustment - NORAUTO 2274271-NO0536-IE12 Manual Del Usuario

USAGE
EN
5-POINT HARNESS USE
1. Hold both buckle tongues. The right side should be slightly upper.
2. Snap two buckle tongues together. Pay attention to the back and front of the buckle tongues.
3. Slide towards buckle for tightening of the harness. You should hear an audible CLICK.
4. Tighten the harness straps. Check that buckle is fastened.
5. To tighten the harness, first, pull up the shoulder straps and the lap straps will tighten. Then, pull on the adjuster strap. Pull any excess
the harness webbing through the buckle towards the child's shoulders and pull on the adjuster strap. This may need to be repeated
several times for proper fit.
6. Verify that the harness is snug around the child's waist and shoulders. After tightening the straps, adjust the shoulder pads to the
appropriate position on the chest. Check that the crotch pad is not bent or crooked.
NOTES:
• Tighten the straps as tightly as possible without causing any discomfort to the child.
• A snug harness cannot be pinched, and should not allow any slack.
• Ensure the harness is snug around the child and lays flat.
• Ensure that nothing interferes with the harness.
• The lap straps should be as low as possible, close to your baby's crotch, not the belly.
WARNING: Loose straps are dangerous. Serious injury or death could occur to a child that is not secured
properly. Ensure that the straps are adjusted properly.
7. To loosen the harness, press on the harness release button while pulling forward on the shoulder straps.
8. Press the straps release button to release the buckle tongues. Separate chest clip and spread the
harness straps apart.
HEADREST ADJUSTMENT
The height can be changed for child comfort.
CAUTION 1: When using as an enhanced child restraint system (76-105 cm), 1-5 levels are available.
1. With loose harness, press the headrest adjusts button, and move the headrest up or down to the desired
position.
2. Release adjust button and slide headrest slightly up or down to lock into the appropriate use position.
NOTE: A correctly adjusted headrest ensures optimal protection of the child in the enhanced child restraint
system. Adjust the headrest so that the shoulder straps are at the same level as your child's shoulders.
Shoulder straps are too low.
CAUTION 2: When using as a booster seat (100-135 cm), 6-10 levels are available.
NOTE: When child grow up above 100cm, the headrest should use 6-10 level height.
1. Slide the strap loops off from the gear fixed axle. Slide the left shoulder strap first, and then the right one. Remove
the shoulder straps.
2. Then, from the front of the enhanced child restraint system, pull out shoulder straps through the slots. Put them
on below of the cloth cover.
3. After remove them, take out the gears fixed axle from the plastic stator and storage it.
4. Select the correct height of the headrest.
IMPORTANT: The lower edge of the headrest should be at a finger distance from
the child's shoulder.
CAUTION: The shoulder straps must not run behind the child's back, at ear height,
or above the ears.

ANGLE ADJUSTMENT

Push the recline handle and adjust the seat to the desired position. Release the
handle. You will hear an audible CLICK!
This enhanced child restraint system has 4 recline positions. Recline can be changed
for child comfort or to improve the installation of enhanced child restraint system.
NOTE: If the display window does not turn into a green colour, pull or push the seat
until it click into place and the indicator turn t into a green colour.
CAUTION: Before securing the child into the enhanced child restraint system, ensure
that the display window turns into a green colour.
36
1
Shoulder straps are too high.
The display window turns into a green colour.
2
Shoulder straps are adjusted properly.
green
3
recline handle
4