AEG SWB66001DG Manual Del Usuario página 66

66 www.aeg.com
If the installation site requires. Tools you
will need:
1. Cross-shaped screwdriver
2. Putty knife or thin-blade screw driver
Before you start lay the wine cooler on its
back in order to gain access to the base,
you should rest it on soft foam packaging
or similar material to avoid damaging the
cooling pipes at the rear of the wine
cooler.
3. Stand the wine cooler, open the door
and remove the shelves and close it
(preventing the shelves are dam-
aged).
4. Remove the bottom hinge by un-
screwing the four lock screws. Be
careful to hold the glass door firmly
after removing the screws.
5. Gently remove the upper door and
set it on a non scratching surface
with the outside up to avoid the risk
of damage.
NOTE: When removing the door, watch
for washer(s) between the ceter hinge
and the bottom of the freezer door that
may stick to the door. Do not lose.
6. Unscrew the upper hinge which at
the top right corner of the wine cooler,
and then use a putty knife or thin
blade screwdriver to prize the screw
hole cover which at the left side
comer of the wine cooler, re-cover
the screw holes on the right hand
side.
7. Screw the alternative left top hinge
(included in the fittings) to the top left
corner of the wine cooler and tighten
securely.